Entering Characters
Follow the steps below when the character entry screen is displayed.
-
Enter characters.
Press
to select characters and then press
or
until the character to enter is displayed. (Repeat this)
To repeatedly enter the same character, rotate
or
to the right to move the entry position cursor.
If you select an item and press
or
, you can perform the following operations:
– []: Change the character type to [A] (upper case characters), [a] (lower case characters), [1] (numbers), and [&] (special characters)
– [ ]: Enter a blank
– [Delete]: Delete a character
– []: Move the entry position cursor to the left
– []: Move the entry position cursor to the right
When entering a password, (A) shows the number of characters you have entered and the number of characters you can enter.
-
Complete entering.
Select [Set] and then press
or
.