Printing
If you connect the camera to a printer that supports PictBridge, you can select pictures on the camera’s monitor and then print them.
Getting started:
Turn on the camera and printer.
Set the print quality and other settings on the printer.
-
Play back the card that contains the picture you want to print.
Press [].
After pressing [], press to select [Card Slot 1] or [Card Slot 2], and then press or .
The card for printing cannot be changed after connecting to the printer.
-
Connect the camera and printer with the USB connection cable. (USB port)
-
Press to select [PictBridge(PTP)] and then press or .
-
Press to select a picture and then press or .
To print multiple pictures, press , set the picture selection method, and then select pictures.
[Multi Select]
Selects the picture to print.
-
Press to select a picture and then press or .
To cancel the setting, press or again.
-
Press [DISP.] to end selection.
[Select All]
Prints all the stored pictures.
[Rating]
Prints all pictures with [Rating] levels from [1] to [5].
-
Set the print settings.
-
Start printing.
Select [Print start] and then press or .
Setting Items (Print Settings)
[Print start] |
Starts printing. |
[Print with Date] |
Sets printing with date. If the printer does not support printing with date, the date cannot be printed. |
[Num.of prints] |
Sets the number of prints to be printed (up to 999). |
[Paper Size] |
Sets the paper size. |
[Page Layout] |
Sets whether to add borders and how many images to be printed on each sheet of paper. |
If [USB Mode] is set to [PictBridge(PTP)] in the [Setup] ([IN/OUT]) menu, the camera will be automatically connected to the printer without the [USB Mode] selection screen being displayed. ([USB]) Take care not to turn off the camera while printing is in progress. When connecting with the printer is not possible, set [USB Power Supply] to [OFF] and then try connecting again. ([USB]) Do not disconnect the USB connection cable while [] (Cable disconnect prohibit icon) is displayed. Disconnect the USB connection cable after printing. Turn off the camera and disconnect the USB connection cable before removing the card from the camera. Otherwise, the recorded data may be damaged. To print images with paper size and layout settings not supported by the camera, set the [Paper Size] and [Page Layout] to [] and then select the desired settings on the printer. (For details, refer to the operating instructions for your printer.) If a yellow [] is displayed, the camera is receiving an error message from the printer. Check that there is no problem with the printer. If the number of prints is high, the pictures may be printed in batches. In this case, the remaining number of prints indicated may differ from the number set. RAW images cannot be printed. Images recorded with the following functions cannot be printed: – Video recording/[6K/4K PHOTO]/[Post-Focus] |