Panasonic

[Loop Recording (video)]

icon_mode-photo_grayicon_mode-movie

icon_mode-ia_grayicon_mode-p_grayicon_mode-a_grayicon_mode-s_grayicon_mode-m_grayicon_mode-creative-motionicon_mode-slow-and-quick-motion_gray

Recording continues until the card becomes full, while dividing videos into short periods.

When the card becomes full, recording continues while deleting the old data.

This is a convenient function for recording over long periods that might exceed the capacity of the card.


icon_care_s

bullet02Recording and deleting occur at the same time, so you will need a card with a writing speed equivalent to double the bit rate of the recording quality used for recording.

If the writing speed on the card is insufficient, recording may stop.


  1. Set the recording mode to [icon_mode-p-motion_table].

character_bullet-largeSet the mode dial. (character_referenceSelecting the Recording Mode)

  1. Set [Rec. File Format] to [MOV].

character_bullet-largebutton_menu-set character_arrow [icon_movie] character_arrow [icon_video-image-format] character_arrow [Rec. File Format] character_arrow [MOV]

  1. Set [Loop Recording (video)].

character_bullet-largebutton_menu-set character_arrow [icon_movie] character_arrow [icon_video-other] character_arrow [Loop Recording (video)] character_arrow [ON]


bullet02[icon_4k-photo-loop] is displayed on the recording screen.

bullet02When the recording fills the card to capacity, loop recording starts and video recording time is no longer displayed.

gui_loop-rec2_eng


icon_info_s

bullet02Make sure the camera does not turn off during recording.

bullet02Loop recording cannot start if there is insufficient available capacity on the card.

bullet02When the recording time exceeds 12 hours, recording continues with data being deleted in order from the point where recording started.

bullet02When the following functions are being used, [Loop Recording (video)] is not available:

– [Rec Quality] with a bit rate of 400 Mbps or more

– [Live Cropping]