Cautions for Use

The Camera

Keep this unit as far away as possible from electromagnetic equipment (such as microwave ovens, TVs, video games etc.).

If you use this unit on top of or near a TV, the pictures and/or sound on this unit may be disrupted by electromagnetic wave radiation.

Do not use this unit near cell phones because doing so may result in noise adversely affecting the pictures and/or sound.

Recorded data may be damaged, or pictures may be distorted, by strong magnetic fields created by speakers or large motors.

Electromagnetic wave radiation may adversely affect this unit, disturbing the pictures and/or sound.

If this unit is adversely affected by electromagnetic equipment and stops functioning properly, turn this unit off and remove the battery or disconnect AC adaptor. Then reinsert the battery or reconnect AC adaptor and turn this unit on.

Do not use this unit near radio transmitters or high-voltage lines.

If you record near radio transmitters or high-voltage lines, the recorded pictures and/or sound may be adversely affected.

Always use the supplied cords and cables.

If you use optional accessories, use the cords and the cables supplied with them.

Do not extend the cords or the cables.

Do not spray the camera with insecticides or volatile chemicals.

If the camera is sprayed with such chemicals, the body of the camera may be damaged and the surface finish may peel off.

Do not keep products made of rubber, PVC or similar materials in contact with the camera for a long period of time.

When Using in Cold Places or at Low Temperatures

Skin burns may result if you leave the metal parts of the camera in direct contact with the skin for long periods of time at cold places (environments with temperatures at or below 0 C (32 F), such as ski resorts or places at high altitude).

Use gloves or similar when using it for long periods.

The performance of the battery (Number of pictures that can be taken/available recording time) may decrease temporarily at temperatures between −10 °C and 0 °C (14 F and 32 F).

Keep the battery warm as you are using by keeping it inside your cold weather gear or clothes. Battery performance will recover when the internal temperature rises again.

The battery cannot be charged at temperatures below 0 °C (32 F).

When charging is not possible, the charging light on the camera body blinks red.

If using in cold locations, do not allow water droplets and snow to remain on the camera.

If these are left on the camera, water may freeze in gaps in the camera on/off switch, speaker, and microphone, making these parts difficult to move, and/or leading to reduced volume. This is not a malfunction.

Cleaning

Before cleaning the camera, remove the battery or the DC Coupler, and disconnect the power plug from the electrical outlet. Then wipe the camera with a dry, soft cloth.

When the camera is soiled badly, it can be cleaned by wiping the dirt off with a wrung wet cloth, and then with a dry cloth.

Do not use solvents such as benzine, thinner, alcohol, kitchen detergents, etc., to clean the camera, since it may deteriorate the external case or the coating may peel off.

When using a chemical cloth, be sure to follow the accompanying instructions.

Dirt on the Image Sensor

If dirt gets inside the mount when changing lenses, depending on the recording conditions, it may adhere to the image sensor and appear on the recorded picture.

To prevent debris or dust adhering to internal parts of the body, avoid changing the lens in a dusty environment and always fit the body cap or a lens when storing the camera.

Remove any dirt on the body cap before attaching it.

Dust reduction function

The camera has a dust reduction function that will blow off the dirt and dust that have affixed to the front of the image sensor.

If the dirt is particularly noticeable, from the [Setup] ([Others]) menu, perform [Sensor Cleaning]. ([Sensor Cleaning])

Removing dirt on the image sensor

The image sensor is very precise and delicate, so be sure to observe the following when you do have to clean it yourself.

Blow dust off the surface of the image sensor using a commercially available blower.

Do not blow the dust off with excessive power.

Do not put the blower further inside than the lens mount.

The blower can scratch the image sensor if it touches.

Do not use any objects except a blower brush to clean the image sensor.

If you cannot remove the dirt or dust with the blower, consult the dealer or Panasonic.

Cleaning the Viewfinder

If the viewfinder becomes dirty, blow dirt off the surface of the viewfinder using a commercially available blower, then lightly wipe with a soft dry cloth.

The eye cup cannot be removed, so make sure it does not come loose when cleaning the viewfinder.

If the eye cup accidentally gets removed, consult the dealer or Panasonic.

Monitor/Viewfinder

Do not push hard on the monitor.

This may cause irregular coloration or malfunction.

Extremely high precision technology is employed to produce the monitor/viewfinder screen. However there may be some dark or bright spots, or spots that light constantly (red, blue, or green) on the screen.

This is not a malfunction.

Though the monitor/viewfinder screen parts are produced with highly controlled precision technology, some pixels may be inactive or always lit.

The spots will not be recorded on images on a card.

Lens

When using this lens, take care not to drop, bump, or apply undue force to it.

Doing so may cause malfunction or damage to this lens and the digital camera.

Do not aim the lens at the sun or strong light sources.

The concentrated light may cause fire or damage.

Do not allow strong light beams, such as laser light, to be directly exposed to this camera (lens). These can destroy the image sensor and cause the camera to malfunction.

Images may be affected by dust, dirt, and soiling (water, oil, fingerprints, etc.) on the lens surface.

Before and after recording, use a blower to blow off dust and dirt from the surface of the lens, then lightly wipe with a soft dry cloth to remove soiling.

When the camera is not being used, attach the lens cap and lens rear cap to prevent dust and dirt from adhering to or entering the camera.

To protect the lens contact points (A), do not do the following.

These may cause a malfunction.

– Touch the lens contact points.

– Soil the lens contact points.

– Place the lens with its mount surface facing down.

To improve the dust and splash resistant performance of the interchangeable lens (H-ES12060/H-FS12060), a lens mount rubber is used in the mount.

– The lens mount rubber will leave scuff marks on the digital camera mount, but this does not impact performance.

– To replace the lens mount rubber, contact Panasonic.

Battery

The battery is a rechargeable lithium ion battery.

It is highly sensitive to temperature and humidity, and the effect on performance increases as the temperature rises or drops.

Do not let the battery terminals (B) become soiled.

Wipe with a dry cloth if they become soiled.

Always remove the battery after use.

Place the removed battery in a plastic bag, etc., and keep away from metallic objects (clips, etc.) for storage or transport.

If you drop the battery accidentally, check to see if the body of the battery and the contacts are deformed.

Damage to the camera will result if a battery with deformed contacts is inserted into the camera.

Dispose of unusable battery.

The battery has a limited life.

Do not throw the battery into fire because it may cause an explosion.

Do not allow battery terminals to come into contact with metal objects (such as necklaces, hairpins, etc.).

This can cause short-circuiting or heat generation and you may be badly burned if you touch a battery.

AC Adaptor

The charging lights may blink under the influence of static electricity or electromagnetic wave, depending on the charging environment. This phenomenon has no effects on charging.

If you use the battery charger near a radio, the radio reception may be disturbed.

Keep the charger 1 m (3.3 feet) or more away from radio.

During usage, the AC adaptor may emit an electrical hum; this is not a malfunction.

After use, be sure to disconnect the power plug from the electrical outlet.

(A very small amount of current is consumed if it is left connected.)

Card

Do not leave the card in areas with high temperatures, direct sunlight, or areas prone to electromagnetic waves and static.

Do not bend or drop the card.

Do not subject the card to strong vibration.

Otherwise, the card and recorded data may be damaged.

Put the card in the card case or the storage bag after use and when storing or carrying the card.

Do not allow dirt, water or other foreign objects to get into the contacts on the card.

Additionally, do not touch the contacts with your hands.

Personal Information

Personal information is stored within the camera and in recorded images.

We recommend that you enhance security by setting a Wi-Fi password and Wi-Fi function lock to protect personal information. ([Wi-Fi Setup] Menu)

Images may contain information that can be used to identify the user, such as recording dates and times, and location information.

Disclaimer

Information including personal information may be altered or vanish due to erroneous operation, effect of static electricity, accident, malfunction, repair, or other handlings.

Please note in advance that Panasonic is not liable in any way for any direct or indirect damage from the alteration or vanishing of information or personal information.

When requesting a repair or transferring/disposing of the camera

After making a copy of personal information, be sure to delete information, including personal information, such as wireless LAN connection settings that you have registered or saved within the camera with [Reset] ([Reset]).

Reset the settings to protect the personal information. ([Reset])

Remove the card from the camera.

Settings may return to factory default when camera is repaired.

Please contact the dealer where you purchased the camera or Panasonic if above operations are not possible due to malfunction.

Points to remember when disposing of/transferring the memory card

Format or delete using the camera or a PC will only modify the file management information, so it will not delete the data in the card completely.

We recommend physically destroying the card or using commercially available PC data deletion software to delete the card data completely when disposing of/transferring the card.

You are responsible for handling of data on cards.

When Not Using the Camera for a Long Period of Time

Ensure you remove the battery and card from the camera.

If the battery is left in the camera, it may over-discharge, and be rendered unusable even after charging.

Store the battery in a cool and dry place with a relatively stable temperature.

(Recommended temperature: 15 C to 25 C (59 F to 77 F); recommended humidity: 40 %RH to 60 %RH)

If storing for a long period of time, it is recommended that the battery be charged once per year, fully drained in the camera, then removed from the camera and then stored again.

We recommend storing the camera with a desiccant (silica gel) when you keep it in a closet or a cabinet.

Check all the parts before recording when you have not used the camera for a long period of time.

Image Data

Recorded data may be damaged or lost if the camera breaks down due to inappropriate handling.

Panasonic will not be liable for any damage caused due to loss of recorded data.

Tripod

Make sure the tripod is stable when the camera is attached to it.

When using a tripod, removal of the battery may not be possible.

Care is required because tightening the screw excessively may damage the camera, or cause the rating label to come off.

Depending on the type of tripod you are using, the lens may interfere with the tripod head if the lens you are using has a large diameter.

Attempting to tighten the tripod screws in this case may cause damage to the camera or the lens.

We recommend using the Tripod Adaptor (DMW-TA1: optional).

Please also refer to the operating instructions for the tripod.

Shoulder Strap

If you attach a heavy interchangeable lens to the camera body, do not carry the camera by the shoulder strap.

Hold the camera and the lens when carrying them.

Wi-Fi Function

Use the camera as a wireless LAN device.

When using devices or computer systems that require more reliable security than wireless LAN devices, ensure that the appropriate measures are taken for safety designs and defects for the systems used.

Panasonic will not take any responsibility for any damage that arises when using the camera for any purpose other than as a wireless LAN device.

Use of the Wi-Fi function of the camera is presumed to be in countries where it is sold.

There is the risk that the camera violates the radio wave regulations if used in countries other than those where it is sold, and Panasonic takes no responsibility for any violations.

There is the risk that data sent and received via radio waves may be intercepted.

Please note that there is the risk that data sent and received via radio waves may be intercepted by a third party.

Do not use the camera in areas with magnetic fields, static electricity or interference.

Do not use the camera in areas with magnetic fields, static electricity or interference, such as near microwave ovens.

These may cause the interruption of the radio waves.

Using the camera near devices such as microwave ovens or cordless telephones that use the 2.4 GHz radio wave band may cause a decrease in performance in both devices.

Do not connect to the wireless network you are not authorized to use.

When using Wi-Fi, wireless networks (SSID) that you are not allowed to use may be displayed, but you should not connect to these as it may be viewed as unauthorized access.