Panasonic

Inserting Cards (Optional)

icon_care_s

bullet02Format the cards with the camera before use. (character_reference[Card Format])


This camera supports the double card slot function.

When two cards are used, relay recording, backup recording, and allocation recording are available.


image_card-insert-1_qg

image_card-insert-2_qg

image_card-insert-3_qg

(A) Card slot 1: CFexpress card

(B) Card slot 2: SD card


bullet02Match the orientation of the cards as shown in the figure and then insert them firmly until they click.


icon_related-info_s

bullet02You can set the way to record to card slots 1 and 2:

(character_reference[Double Card Slot Function])

bullet02You can set the folder and file name where to save the images:

(character_reference[Folder / File Settings])


character_diamondCard Access Indications

The card access light turns on while the card is being accessed.

image_access-lamp

(C) Card access light for card slot 1

(D) Card access light for card slot 2


bullet02The rear card access light also turns on while the card is being accessed.

image_rear-tally-lamp

(E) Rear card access light


icon_info_s

bullet02The card may be warm just after the camera has been used.

bullet02Do not perform the following operations during access.

The camera may operate incorrectly or the card and recorded images may be damaged.

– Turn off the camera.

– Remove the battery or card or disconnect the power plug.

– Subject the camera to vibration, impacts, or static electricity.

icon_related-info_s

bullet02You can set whether to have the rear card access light turn on/off. You can also change the brightness of the rear card access light:

(character_reference[Tally Lamp])


character_diamondRemoving a Card

image_remove-card

  1. Open the card door.

  1. Push the card until it clicks and then pull the card out straight.

bullet02Check that the card access lights are off before removing the card.